Waterproof polyethylene membrane coated on both sides by a support mesh. Waterproof sheet that can be applied on tiles, walls, floors or roofs.

Drainage system for horizontal covers, which is placed below the finishing coat. It consists of a uniformly leaky polyethylene sheet, which allows the water to flow through the waterproof sloping sheet of the cover to the drain.

Waterproofing sheet for polyethylene, loading and distilling. Its use is ideal for new buildings and the renovation of balconies and terraces. Polyethylene sheet, with ribbed ribbons in the form of a milano tail, with a mesh supporting back. Its main functions are: decoupling, waterproofing, protection, compensation of vapour pressure and repair of cracks.

Drain substrate for green covers, in their composition use aggregates from recycled stone materials. For extensive or intensive vegetation.

Plate with a vein mesh structure of 50 mm made of 60% black recycled polypropylene, with a synthetic felt layer on the underside (and on the upper side, on the model 1F). It is a useful system for the temporary retention of rainwater on flat roofs.

It is a drainage mesh in flat, non-crossable roofs. Model 1F is also suitable for gravel stabilization on roofs that are very exposed to the wind.

Nidaroof 100-2F: 2.40 m x 1.20 m and thickness of 100 mm, Nidaroof 520-2F: 2.40 m x 1.20 m and thickness of 520 mm, Nidaroof 40-1F: 2.40 m x 1.20 m and thickness of 40 mm, Nidaroof 60 -1F: 2.40 m x 1.20 m and thickness of 60 mm.

Geomembrane of high density polyethylene (HDPE), homogeneous and black. It is made of 97.2% polyethylene, 2.2% carbon black, antioxidants and stabilizers. It is resistant to various chemical aggressions. It has good behavior in UV rays and allows a direct exposure.

Waterproofing of all types of hydraulic constructions. Suitable for stoking hydrocarbons, heavy metals, acidic and basic solutions.

Thickness (mm) Width (m) Length (m): Geonap 3 m 1.0 3 200, Geonap 3 m 1.5 3 140, Geonap 3 m 2.0 3 100, Geonap 6 m 1.0 6 200, Geonap 6 m 1.5 6 140, Geonap 6 m 2.0 6 100. It is also available in rolls of 5.70 meters of width.

Planitherm is a glass subjected to a surface treatment which gives it the property of low emissivity. This feature allows a significant reduction in solar gain, while maintaining a high light transmission coefficient. The use of Planitherm glass as a component in a double glazing Climalit provides better performance in terms of thermal insulation. A low-emissivity glass allows the penetration of the majority of the sun's short-wave solar radiation and reflects most of the long-wave radiation, which produces, among other sources, the heating systems, being preserved inside the environments. In summer, it allows to reduce up to a 40% the energetic contributions that go through the glasses, and in winter, the thermal insulation capacity is 35% higher than with a glass without the low emissivity treatment. In summary, its efficiency to delay the flow of heat losses or gains between the temperatures of the air on both sides of the glass is greater than a DVH (double tight glass).

It should be used as an internal component of the Climalit double glazing, with the face treated in position 3 and in contact with the air chamber.

Measures to be consulted.

It is a complete system for extensive covers that associates a system of bituminous waterproofing gravel and a protection of finishing plant vegetation through precultivated boxed with water retention. It concentrates in a single element all the 4 components of a landscaped covers system: drainage, filter, substrate and vegetation. The layers of a Graviland cover are as follows: support (concrete, wood, steel), vapour barrier, thermal insulation, gravel waterproofing (Preflex + Graviflex), hydropack pre-hydraulic boxes and a sterile gravel area.

Complete system for the waterproofing of landscaped non-crossable roofs and terraces. Suitable for wooden covers, deck, concrete, etc; non-crossable roofs and terraces with a slope of ≤ 20%.

Perflex: roll of 10 m x 1m. Palette of 25 rolls Graviflex: roll of 8 m x 1 m. Palette of 24 rolls Hydropack: box of 600 x 400 x 90 mm. 14.4 m2 pallet.

Waterproofing roof system, composed of a self-protected asphalt sheet on its surface with Noxite® granules (titanium dioxide), which is a decontaminating agent by photo-catalysis, which reduces the atmospheric pollution. Noxite® covering the NOx-Activ® sheet, under the effect of UVA rays of sunlight, causes a decomposition of contaminating oxides (NOx) in by-products that are evacuated by rainwater. The decontaminating effect obtained is permanent throughout the service life of the waterproofing.

In new construction or rehabilitation, based on a monolayer or bilayer system of asphalt waterproofing, mechanically fixed or braided to the support, on concrete, steel plate (deck) or any other element.

Asphalt sheets or plates.

Monolayer waterproofing system with bituminous base, incorporating amorphous silicon flexible photovoltaic modules. The bitumen waterproofing sheet does not need additional self-protection against UV rays. Self-cleaning modules. The system mass is less than 8 kg/m2.

Suitable for waterproofing roofs in rehabilitation and new construction. They can be welded on a concrete support, thermal insulation, old waterproofing layer, fiber cement sheets and metal corrugated sheets (deck roof). It is especially indicated for light roofs. It needs to be placed with a minimum slope of 3%.

Icosun Top S: roll of 1 m x 6 m, pallet of 25 rolls / 1 m x 11.60 m, pallet of 14 rolls. PVL module: PVL 68 box of 20 modules of 0.40 x 2.85 m PVL 136 box of 20 modules of 0.40 x 5.50 m PVL 144 box of 20 modules of 0.40 x 5.50 m.

Green roofs systems, with the possibility of a wide variety of uses. A complete and specific system is commercialized for this application. The system is based on a draining system on which the substrate is placed. This system contemplates three types of draining elements for different applications: extensive landscaping on sloping roofs, extensive landscaping for high demands and intensive for low demands and for multiple uses of landscaped roofs. The system, besides the drainage, has studied different types of substrates, the vegetation to be planted and the possible crossable areas. The drainage sheet and the polypropylene felts are made of recycled material. The substrates use aggregates of recycled stony materials in their composition.

The product included is a median representative blackboard of the Spanish slater sector and that includes different slate formats.

The main recommended use for this product is the coating for covers thanks to its properties of impermeability, resistance to frost, resistance to bending and durability.

There are different slate formats ranging from small formats such as 32x22 cm to the larger ones, such as 50x25 cm. The thicknesses can range from 3.5 mm to 4.5 mm.

The Sopranature system allows the waterproofing of roofs, producing integrated vegetation in the environment. In addition to the improvement of the landscape, the increase of greenery allows a better air quality because of the production of oxygen by the vegetation.

Vegetation cover system divided into two categories: extensive covers and intensive covers. Extensive covers usually have a substrate thickness less than 15 cm and are designed to allow the growth of plant species with little water needs. They are usually non-crossable and their maintenance is low. These covers incorporate recycled elements in both drainage systems and substrates. Intensive decks have a larger substrate thickness, allowing the development of a broad spectrum of plant species; they are usually crossable, incorporate irrigation and their maintenance is higher than in the extensive covers. The vegetal covers provide acoustic and thermal insulation, and provide a good protection of the building structure.

Roofs systems.

Two types: extensive or intensive covers.